Emerson SERIES 600T Manuel D’Utilisation

The Liebert FS shipping package is designed to be handled using a forklift. Forklift operators must 

avoid rough handling when picking up, moving and lowering it.

To reduce the possibility of shipping damage, flywheel cabinets are secured to the pallet by two 

mounting brackets and two banding straps. These same two mounting brackets are used to mount the 

cabinet to the floor. 
Packing elements should be removed in this order to ease unpacking:
1. Cut and remove the banding straps (see Figure 8).

2. Remove hex head bolts holding mounting brackets to pallet as shown in Figure 9.
3. Remove lag bolts holding metal mounting brackets to pallet.
4. Remove mounting brackets from Liebert FS.

Exhibit care when handling Liebert FS cabinet to avoid equipment damage or injury to 

personnel. Failure to do so could throw off the calibration of the mechanical components 

contained in the unit and possibly cause permanent damage.

The Liebert FS has sensitive electronics and mechanical components that have been 

calibrated prior to shipment.

Test lift and balance the cabinet before transporting it. Maintain minimum tilt from vertical 

at all times—do not exceed 15 degrees of tilt.

Sheet metal components and framework may have sharp edges.

Use care when removing banding straps and metal mounting brackets. The banding straps 

are under tension and may snap violently, causing injury. Always wear proper eye and foot 

protection when unpacking or installing the system.