Emerson SERIES 600T Manuel D’Utilisation

Liebert has included a complete anchoring kit with each Liebert FS for surface mounting. The kit is 

intended to securely fasten the Liebert FS to its intended location for operational safety and seismic 

requirements. 
This kit includes (items depicted in Figure 150):

• Two (2) cabinet mounting brackets (from shipping pallet)
• Four (4) concrete expansion anchors
• Two (2) drop-in hex head anchor bolts
• Two (2) washers for anchor bolts
• One (1) masonry drill bit
• One (1) floor mounting template (Figure 149)
• Two (2) drop-in hex flange anchor bolts
• One (1) setter rod or drive pin (specifically designed for measuring hole depth and for expanding 

the anchors)

• Four (4) hex bolts from shipping package, each 1/2" diameter and 3/4" long (12.7mm diameter x 

20mm long)

These tools are needed for the mounting the Liebert FS on the floor:

• Concrete drill with 1/2" (12.7mm) minimum chuck size
• Masonry drill bit (included in mounting kit)
• Masonry drill bit—used for pilot hole—for example, 1/8" (3.2mm) diameter
• Setter rod (included in mounting kit)
• Hammer or mallet, 16 oz. (0.5kg) or larger
• Shop vacuum cleaner (to remove dust from hole when drilling)
• 3/4" (19mm) combination wrench
• 18mm combination wrench

To mount the Liebert FS cabinet on the floor:
1. Prepare a clean, level, finished surface, free of obstructions, for installation of the mounting kit.
2. Tape the floor mounting template mounting template (Figure 149) to the installation location.
3. Using a bit smaller than the one provided in the mounting kit, drill a pilot hole at each of the four 

places marked with an “X” on the template.

4. Remove template and continue with larger drill bit provided.