Emerson SERIES 600T Manuel D’Utilisation

Power and status/control wiring must be run in separate conduits or cable trays. Refer to Appendix 

D.0 - Installation Drawings for locations of the various electrical connections between Liebert FS 

system(s) and UPS system.

Power and status/control wiring must be separated

Do not cut entry holes for conduit while the access plates are still set on the top of the 

Liebert FS cabinet. Remove the access plates from the cable-access areas in the top of the 

Liebert FS cabinet prior to cutting entry holes.

After reinstalling access plates, be certain that no foreign matter (metal shavings, insulation 

or wire fragments, etc.) remains inside the Liebert FS. Likewise, be certain to block any 

“extra holes” in the plates through which foreign matter (or rodents) could later enter the 

Liebert FS.

DC Power
Terminals

Circuit
Breaker

Status/Control
Terminal Block
(upgraded)

Manufacturer’s
Connection

Fan Coil Module

Ground Terminal