Emerson 710NPBA Manuel D’Utilisation
UM581127000
User Instructions
Issue AB, March 22, 2012
Spec. No. 581127000 (Model 710
NPBA
)
Page 14
Chapter 3. Maintenance
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
CHANGING THE ACU+ LVD CONTROL
LEVEL FOR A CONTACTOR
LEVEL FOR A CONTACTOR
The ACU+ Controller has two available LVD control levels (LVD1 and LVD2). The level
used to control a contactor is determined by which connector on the LVD circuit card its
control leads are plugged into. To change the LVD control level for a contactor, simply
switch which LVD connector it is plugged into (if an open connector is available) on the
LVD circuit card. Refer to Figure 4-13 and Figure 4-14 for connector location and
function.
used to control a contactor is determined by which connector on the LVD circuit card its
control leads are plugged into. To change the LVD control level for a contactor, simply
switch which LVD connector it is plugged into (if an open connector is available) on the
LVD circuit card. Refer to Figure 4-13 and Figure 4-14 for connector location and
function.
Note: DO NOT change a Low Voltage Load Disconnect contactor to LVD Control Level
2 (LVD2) if the system is furnished with a Low Voltage Battery Disconnect
contactor.
contactor.