Emerson 240V Manuel D’Utilisation

1. Lift module to appropriate bay, resting end of module on bay 

shelf. Use caution not to rest the module on the lower bezel 

cover.

2. Push module into bay. Once halfway in, slide module sideways 

toward the center of the UPS. Continue pushing module until 

fully inserted. 

3. Press and turn fastener clockwise until locked. If replacing a 

Control or Power Module, press lever down. 

4. Wait about 15 seconds as the module performs a start-up test 

and synchronizes with the other modules. Both the yellow and 

green LEDs should be flashing. A green flashing LED will 

then confirm the module is properly installed.

5. If UPS was placed in bypass manually, transfer back to UPS 

operation.

6. Replace bezels.

1. Lift off user interface and set it on top 

of the UPS frame.

2. The attached cable will be connected to 

an Intellislot card, found in a port 

between the control modules. 

3. Remove the cable and the attached 

Intellislot card from the UPS.

4. Plug the new Intellislot card into the 

UPS.

5. Plug the new user interface cable into 

the Intellislot card.

6. Set replacement User Interface into 

proper position.

NOTE
Power Modules must be installed in the top half of the Nfinity frame. Battery Modules can be 

NOTE
When replacing the Control Module, record user configuration data before removing. Re-verify