Emerson 4015 Manuel D’Utilisation
Installation Instructions
IM584000300
Spec. No. 584000300 (Model 4015-X003)
Issue AB, April 3, 2013
Static Warning
Page vii
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
STATIC WARNING
The printed circuit cards used in this equipment contain static sensitive components. The
warnings listed below must be observed to prevent damage to these components. Disregarding
any of these warnings may result in personal injury or damage to the equipment.
warnings listed below must be observed to prevent damage to these components. Disregarding
any of these warnings may result in personal injury or damage to the equipment.
1. Strictly adhere to the procedures provided in this document.
2. Before touching any static sensitive component or printed circuit card containing such a
component, discharge all static electricity from yourself by wearing a wrist strap grounded
through a one megohm resistor. Some wrist straps, such as Emerson Network Power Part
Number 631810600, have a built-in one megohm resistor; no external resistor is necessary.
Read and follow wrist strap manufacturer’s instructions outlining use of a specific wrist strap.
through a one megohm resistor. Some wrist straps, such as Emerson Network Power Part
Number 631810600, have a built-in one megohm resistor; no external resistor is necessary.
Read and follow wrist strap manufacturer’s instructions outlining use of a specific wrist strap.
3. Do not touch the traces or components on a printed circuit card containing static sensitive
components. Handle the printed circuit card only by the edges that do not have connector
pads.
pads.
4. After removing a printed circuit card containing a static sensitive component, place the
printed circuit card only on conductive or anti-static material such as conductive foam,
conductive plastic, or aluminum foil. Do not use ordinary Styrofoam or ordinary plastic.
conductive plastic, or aluminum foil. Do not use ordinary Styrofoam or ordinary plastic.
5. Store and ship static sensitive devices or printed circuit cards containing such components
only in static shielding containers.
6. If necessary to repair a printed circuit card containing a static sensitive component, wear an
appropriately grounded wrist strap, work on a conductive surface, use a grounded soldering
iron, and use grounded test equipment.
iron, and use grounded test equipment.