Emerson 400V Manuel D’Utilisation

The UPS provides input dry contacts and output dry contacts.

There are several input dry contacts at the X3 slot.

X3 IN DRY: Environmental, Battery Ground Fault and Generator Contacts
The UPS accepts external signalling from voltage-free (dry) contacts connected to finger-proof, push-

in terminal X3 IN DRY. Subject to prior software programming, the signalling is accepted by the UPS 

when connection between the relevant terminal and the +12V terminal is altered. Cables connected to 

X3 IN DRY must be segregated from power circuits (for screening purposes), double insulated and of a 

typical 0.5 to 1mm

2

 cross-section area for maximum runs between 25 and 50 meters (82-164 ft), 

respectively.

J4.1

ENV

3

Battery Room Alarm (NC)

J4.2

BtG

Battery Ground Fault Detection (NC)

J4.3

GEN

1,2

On Generator (NO)

J4.4

+12V

+12V Power

1 - Must be configured by configuration software before becoming active.
2 - When activated, the charger current can be limited, via software, to a percentage of the full charger current (0-100%).
3 - Activating this feature turns the battery charger off.

NOTE
All auxiliary cables of terminal must be double-insulated. Wire should be 0.5-1.5mm