Emerson 208V Manuel D’Utilisation

5. Extend the slide rail assembly by sliding the front member forward until it touches the rack’s 

front vertical rails (adjustable length: 18 to 32 inches [457-813mm]). Use two M5 screws to fix 

each front member onto the front vertical rails through the installation holes. Make sure that 

slide rail assemblies are at the same mounting height on all four rack rails, as shown in 

6. Fasten rear member and front member together using four M4 screws and four M4 nuts (M4 nuts 

have been factory-installed on the rear member) per slide rail assembly, as shown in Figure 14.

7. Fasten inner members pulled from the slide rail assemblies in Step 2 to the UPS on both sides 

with eight M4 screws provided in this kit. Make sure that the retaining latch is near the rear of 

the UPS, as shown in Figure 15.

8. Use M4 screws to install ears of accessories on both sides of the UPS, as shown in Figure 16.

Rear
Member

Front
Vertical
Pole

Front

Member

M5 Screw
4 pieces

Slide

M4 Screw, 8 pieces

Rear Member

Front member

M4 Nut, 8 pieces

M4 screw, 8 pieces

Retaining Latch

Liebert GXT3 UPS

Inner Member