3com 3644A Manuel D’Utilisation

 

20

       Login in the identity of “Manager” and then select the quick icon after the system restarts. The dialogue

frame as shown in Fig.4-3 will be displayed.

                                                          Fig 4-3 COM Port and address set

       In Fig. 4-3, select the COM port from the pull-down table. If the COM port  does not exit, the system will

prompt the diagram as shown in Fig. 4-4. And click the “OK” button and the page key “ADDRESS” are out of work.

And vice versa. (And users must be in the identity of the “Manager” otherwise the “ADDRESS” cannot be used.

       Fig 4-4 COM Port Failure Opening frame

       Set Default POWER Address:

                    The system will automatically be in the networking state after the start according to the default COM port and

       the default POWER. It is just needed to enter the address in the “Default POWER” bar.

        Set POWER Address:

                    Login in the identity of the “Manager” and select the existing COM port. Then the “ADDRESS” page key

         will be available.

              Fig 4-5 POWER Address Set