Pelco C561M-I (4/08) Manuel D’Utilisation
6
C561M-I (4/08)
OUTPUT WIRING
To install the output wiring to the camera, dome, or positioning system, refer to Figure 4 on page 6 and
perform the following steps:
perform the following steps:
1. Refer to Table A on page 7 and determine the output connection needed for your camera, dome, or
positioning system. Refer to Figure 4 on page 6, for the proper connector strip connections.
2. Attach one output wire to either the Tap A (24 VAC), Tap B (26 VAC), or Tap C (28 VAC) connections
on the Secondary Output Tap connector strip and attach the second wire to the COM connection on
the same strip. Be sure that you have the proper wiring size and distances installed if you plan to
change connections later.
the same strip. Be sure that you have the proper wiring size and distances installed if you plan to
change connections later.
3. Close the lid to the WCS1-4 power supply, replace the retaining screw to the door latch, and then
turn on the power.
Figure 4. Wiring Connector Diagram
120V-F 1.6AH
240V-F 0.5AH
240V-F 0.5AH
Primary Line Input
Seconday Output Taps