ADC Power Distribution Manuel D’Utilisation

ADCP-80-575 • Issue 2 • December 2006

Page 4
© 2006, ADC Telecommunications, Inc.

The fuse platform is shipped with hardware components (shown in 

) that are packaged

separately and enclosed in the same carton. The packaged hardware components include the
following items: 

• Two sets of mounting brackets (for 19-inch or 23-inch rack mounting)—Used to mount

the panel on the equipment rack.

• 5/16-inch long, Phillips drive, 8-32 flat-head thread-forming screws (8)—Used to secure

the mounting brackets to the panel. 

• 3/8-inch long, combination drive, 12-24 pan-head screws (4) and #12 flat washers (4)—

Used to secure the mounting brackets to the equipment rack. 

• #10 ring terminals (2) for 12–10 AWG wire—Used to connect the grounding cables to the

grounding studs. 

• Rear protective input terminal covers and output terminal covers—Used to prevent

accidental contact with the power input and output terminals. The number of covers
provided depends on the fuse configuration.

• Designation card and card holder—Used to record information about the protected

equipment. The card holder has a pressure-sensitive adhesive backing to permit
attachment to the panel, the rack, or a location close to the panel. The designation card
inserts into the card holder. It is also available as an accessory item.