APC AP89XX Manuel D’Utilisation

You can configure event actions to occur in response to an event or group of events. These actions notify 

users of the event in any of several ways:

•  Active, automatic notification. The specified users or monitoring devices are contacted directly.

– E-mail notification

– SNMP traps

– APC Remote Monitoring Service

– Syslog notification

•  Indirect notification 

– Event log. If no direct notification is configured, users must check the log to determine which 

events have occurred

You can also log system performance data to use for device monitoring. See “Data log” on 

– Queries (SNMP GETs)

For more information, see “SNMP” on page 87. SNMP enables an NMS to perform 
informational queries. For SNMPv1, which does not encrypt data before transmission, 
configuring the most restrictive SNMP access type (READ) enables informational queries 
without the risk of allowing remote configuration changes.

For events that have an associated clearing event, you can also set the 

following parameters as you configure events individually or by group, as described in the next two 
sections. To access the parameters, click the receiver or recipient name.

Delay x time before 
sending

If the event persists for the specified time, a notification is sent. If the condition clears 
before the time expires, no notification is sent.

Repeat at an interval 
of x time

The notification is sent at the specified interval (e.g., every 2 minutes).

Up to x times

During an active event, the notification repeats for this number of times.

Until condition 
clears

The notification is sent repeatedly until the condition clears or is resolved.