APC AP89XX Manuel D’Utilisation

The Device IP Configuration Wizard configures the IP address, subnet mask, and default gateway of one 
or more Rack PDUs or network-enabled devices (devices containing an embedded APC Network 
Management Card [NMC]). You can use the Wizard in either of the following ways:

•  Remotely over your TCP/IP network to discover and configure unconfigured Rack PDUs or 

devices on the same network segment as the computer running the Wizard.

•  Through a direct connection from a serial port of your computer to a Rack PDU or device to 

configure or reconfigure it.

Version 5.0.0 or higher of the Wizard runs on Microsoft Windows 2000, Windows Server® 2003, 
Windows Server® 2008 Windows XP, Windows Vista, and Windows 7.

To install the Wizard from a downloaded executable file:

1. Go to www.apc/tools/download.

2. Download the Device IP Configuration Wizard.

3. Run the executable file in the folder to which you downloaded it.

Most software firewalls must be temporarily disabled for the Wizard to discover unconfigured Rack 
PDUs.

The installation creates a shortcut link in the Start menu to launch the Wizard.

Before you run the Wizard:

1. Contact your network administrator to obtain valid TCP/IP settings.

2. If you are configuring multiple unconfigured Rack PDUs or network-enabled devices, obtain the 

MAC address of each one to identify it when the Wizard discovers it. (The Wizard displays the 
MAC address on the screen on which you then enter the TCP/IP settings.) The MAC address can 
be found:

• On a label on the device

• On the Quality Assurance slip that came with the Rack PDU or device