APC AP89XX Manuel D’Utilisation

Administrator, Device User

 Determine whether the device with the IP address or DNS name you specify is connected 

to the network. Four inquiries are sent to the address.

To determine whether a device with an IP address of 150.250.6.10 is connected to the 

network, type:

ping 150.250.6.10

Administrator

To configure the TCP/IP port to communicate using 100 Mbps with half-duplex 

communication (communication in only one direction at a time), type:

portspeed -s 100H

Administrator, Device User

Configure the command line interface prompt to include or exclude the account type of 

the currently logged-in user. Any user can change this setting; all user accounts will be updated to use the 
new setting.

To include the account type of the currently logged-in user in the command prompt, type:

prompt -s long

Administrator, Device User, Outlet User

Exit from the command line interface session (this works the same as the exit command).

<IP address or DNS name>

Type an IP address with the format xxx.xxx.xxx.xxx, or the DNS name 
configured by the DNS server.

-s

auto | 10H | 10F | 
100H | 100 F

Define the communication speed of the Ethernet port. The auto command 
enables the Ethernet devices to negotiate to transmit at the highest possible 
speed. See “Port Speed” on page 83 for more information about the port speed 
settings.

-s

long

The prompt includes the account type of the currently logged-in user.

short

The default setting. The prompt is four characters long: APC>