Samsung P50HP-2 Manuel D’Utilisation

• Do not use benzene, thinner or other flammable sub-

stances, or a wet cloth.

2) Maintaining the Flat Panel Display Screen.

Clean with a soft cloth (cotton flannel) smoothly.

• Never use acetone, benzene or thinner.

(They may cause flaws or deformation of the screen

surface.)

• The user will be required to pay costs and related

expenses for repairing damages caused.

Symptoms and Recommended Actions

Note

A PDP Display recreates visual signals received from the computer. Therefore, if there is a

problem with the computer or the video card, this can cause the PDP Display to become

blank, have poor coloring, become noisy, and video mode not supported, etc. In this case,

1. Check if the power cord and the video cables are properly connected to the computer.

2. Check if the computer beeps more than 3 times when booting.

(If it does, request an a service for the main board of the computer.)

3. If you installed a new video card or if you assembled the PC, check if you installed the

Adaptor(video).

4. Check if the scanning ratio of the video screen is set to between 50 Hz ~ 85 Hz.

(Do not exceed 60Hz when using the maximum resolution.)

5. If you have problems in installing the Adaptor (video) driver, boot the computer in Safe

Mode, remove the Display Adaptor in the "Control Panel −> System −> Device Admin-

istrator" and then reboot the computer to reinstall the Adaptor (video) driver.

Check List

Note

• The following table lists possible problems and their solutions. Before calling for assis-

tance, check the information in this section to see if you can remedy any problems for

yourself. If you do need assistance, please call the phone number on the Information

Problems related to the Installation (PC Mode)

Note

Problems related to the PDP Display installation and their solutions are listed.

The PDP Display screen flickers.

Troubleshooting