Panasonic PT-FW300NTU Manuel D’Utilisation

J Replacement procedure

1. Turn the projector upside down and place it gently 

on a soft cloth.

2. Use a Phillips-head screwdriver to loosen 3 ACF 

cover fixing screws until the screws turn freely and 
remove the ACF cover.

3. Release the lock by pushing in the lock clamp to 

inside, and slide out the ACF unit from the 
projector slowly.

4. Insert the new ACF unit into the compartment in 

correct direction and slightly push down until it 
clicks. Tighten an ACF fixing screw securely with a 
Phillips-head screwdriver.

5. Attach the ACF cover and tighten the ACF cover 

fixing screws securely with a Phillips-head 
screwdriver.

J Resetting the REMAINING 

1. Turn on the projector and display the FILTER 

COUNTER RESET in PROJECTOR SETUP.

2. Press the ENTER button for more than 3 seconds.

  The confirmation screen will be displayed.

3. Select OK by pressing 

I, then press the ENTER 

button.

4. Display the STATUS and confirm the figure.

• If the ACF and/or ACF cover are attached incorrectly, 

the projector may not be turned on.

• Do not switch the power on while the ACF cover 

removed.

• When you replace the ACF unit, clean the compartment 

and/or the air exhaust port if you need to.

• The replacement timing of the ACF is 36 000 hours of 

use at maximum and it depends on environment of 
usage.

ACF cover

ACF cover fixing screw

Soft cloth

Clamp

ACF

Push in

Push in

RESET FILTER COUNTER?

OK

CANCEL

SELECT

ENTER

RETURN

FILTER COUNTER RESET