Panasonic PT-AE1000U Manuel D’Utilisation

When installing the projector, select the projection 
method according to the projector position. Press I H 
to cycle through the options. See “Projection method” 
on page 15.

You can select the required duration of time and set the 
off timer to turn off the POWER of the projector 
automatically. 3 minutes before turn-off, the countdown 
of minutes will be displayed in the lower right corner. 
Press I H to cycle through the options. See “Switching 
off the projector automatically” on page 25.

If you use the projector at high elevations, set the fan 
speed to HIGH. Press I H to select HIGH or LOW.

You can adjust the power of the lamp to save on 
electricity, prolong the lamp life and reduce the noise.

You can check how long the lamp has been used.

You can assign frequently used functions to each 
function button and access the functions instantly.

1. Press F G to select the required button to assign.

2. Press ENTER.

3. Press I H to select the required function to 

assign.

4. Press RETURN or MENU to return to the previous 

menu, or press repeatedly to return to the 
projection.

Q

You can turn off the lamp and stop the projection 
temporary for electrical power save. Press any 
button except the LIGHT, DEVICE or Learning 
Remote control buttons to return to the 
projection.

Setting on a desk/floor and 
projecting from front 

Mounting in the ceiling and 
projecting from front

Setting on a desk/floor and 
projecting from rear

Mounting in the ceiling and 
projecting from rear

NOTE:
 

At 1 400 m (4593 ft) above sea level, the setting 
must be HIGH.

When higher luminance is 
required such as movies

When lower luminance is 
sufficient such as in a small room

NOTE:
 

When no input signal is detected, the function is 
disabled.

NOTE:
 

LAMP RUNTIME is a relevant matter for lamp 
replacement timing. See “Care and Replacement” 
on page 41.

NOTE:
 

See “Selecting the input signal” on page 21, 
“AUTO SETUP” on page 36.

 

The function buttons are also used as Learning 
Remote control buttons. Press the DEVICE button 
to switch the control mode. See “Remote Control 
Operating Guide” provided with the projector.

OFF

OFF

OFF

FUNCTION BUTTON2

FUNCTION BUTTON3

FUNCTION BUTTON1

FUNCTION BUTTON

PT-AE1000U.book  Page 39  Monday, October 16, 2006  1:40 PM