Mitsubishi Electronics WL7200U Manuel D’Utilisation

EN-48

•  The image within the outer edges of the red

frame is captured. 

•  The captured image is displayed in the REAL

mode automatically.

12.Adjust the size of the image to be captured so that 

such image stays within the red frame. 
•  Press the , ,  or  button to move the red 

frame.

•  You can’t move the red frame outside the 

screen. 

•  Press the MENU button to cancel the 

procedure.

13. Press the ENTER button twice.

•  Image capture will start.

CAPTURING IMAGE !

•  When the image capture completes, the 

captured image will be displayed for 1 second. 

Important:
•  You can’t change the new startup screen back to 

the original startup screen. (Even when you select 
RESET ALL in the FEATURE menu, the factory 
default screen isn’t available any longer.) When you 
want to change the startup screen again, capture 
another image.

•  The captured image will be displayed from the 

next startup. If the captured image isn’t displayed, 
make sure that the setting of SPLASH SCREEN in 
the INSTALLATION menu isn’t OFF. (See page 33.)

•  When BACK COLOR in the INSTALLATION menu is 

set to IMAGE, the captured image will be displayed 
while no signal is supplied. 

•  When no video signal is supplied, the projector

takes some time to display the captured image.  

•  Some images can’t be captured correctly because 

of their signal type. 

You can display your desired image as the startup 
screen (or splash screen). By setting the menu, you 
can use such image instead of the background image 
that is displayed when no video signal is supplied.
Important:
•  You can’t set IMAGE CAPTURE when PASSWORD 

FUNCTION in the FEATURE menu has been set to 
SPLASH ID SCREEN to enable the password lock.

•  You can’t set IMAGE CAPTURE when the 

component video signal is inputted.

(See page 31 for menu setting.)  
1.  Press the COMPUTER button to select the image 

supplied to the COMPUTER/COMPONENT/VIDEO 
IN terminal.

2.  Display your desired image.
3.  Display the INSTALLATION menu.
4.  Select IMAGE CAPTURE by pressing the  or  

button.

5.  Press the ENTER button.

•  The setting menu will be displayed.

Set the background color
(Set the background color only when you set the 
image size to x1 or x2.)
6.  Select BACK COLOR by pressing the  or  

button.

7.  Select your desired color for the background 

(GRAY, RED, GREEN, BLUE, BLACK, WHITE, 
RED50%, GREEN50%, or BLUE50%) by pressing
the  or  button. 

Set the image size
8.  Select SIZE by pressing the  or  button.
9.  Select x1, x2, or FULL by pressing the  or  

button. 

x1

x2

FULL

Capture the image
10. Select CAPTURE by pressing the  or  button.
11.Press the ENTER button.

•  A red frame appears. (The size of the red frame 

is 640 x 374 pixels.)