iHome iH52 Manuel D’Utilisation

Install/Replace Backup Battery
The iH52 uses a backup battery system to provide continuous clock settings in the event of a power 
failure. If the Battery Low Icon located on the right of the display is flashing, it is time to replace the backup 
batteries. Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery 
replacement.
•    Open the battery compartment cover located on the bottom of the main receiver unit. Insert 3  
 

“AA” batteries as indicated.

 We recommend the use of alkaline batteries for longer life. 

•  

Please make sure the AC cord is connected; otherwise all settings may be lost during 

      battery replacement.

Batteries information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries.

11

a)   Make sure both the AM and FM antennas are properly attached  
 

and extended/located for best reception.

b)   Press the Radio button. By default, the FM band is selected, but  
 

the unit will revert to the last band in use (AM or FM). Press the  

 

Radio button to toggle between FM and AM bands.

c)   To tune a station, press the Select Down/REW or Select Up/FWD  
 button until the desired frequency appears (hold either button for  
 

faster  selection; the unit will scan to the next station with clear reception).

d)  To save a station as a preset, tune in the desired station then  
 

hold the desired preset button for about two seconds until you hear two confirmation beeps. You can save up to 12 presets (6  

 

AM and 6 FM). To change a preset, follow the same steps for saving a preset. 

e)   To listen to a preset station in radio mode, press the Radio button to select the desired radio band (AM or FM), then press  
 

the desired preset button. The unit will tune to the preset station assigned in the selected band.

a) An audio patch cord comes with the iH52. Use it to play nondocking iPod models or other audio devices through the iH52 

Line-in Jack (one end in the device’s line out or headphones jack, the other in the iH52 line in jack).  Press the iPod Button 
until AUX appears in the display. You can now play your device.

a)  Press the

 Dimmer Button  until “Dimmer” appears on the display. Hold the down/REW Button to dim the display brightness, 

or hold the up/FF Button to brighten the display. When the desired display brightness level is set,  press the Dimmer button 
to return to normal display function.

a)  Press the

 Display Button to switch display modes on your docked iPod and on the iH52 display between standard and extended 

modes. In Extended mode, song information from your iPod appears on the iH52 display. The video out ports  are disabled in 
this mode, as are iPod controls.

DIP switches