ADC MM702G Manuel D’Utilisation
Connect Cables
4
MM701G and MM702G User Manual
2
Connect the cables to the modem rear panel as shown above:
•
silver cable to the DSL line port and wall jack
•
black Ethernet cable to the 10Base-T port and to another Ethernet device such as a PC,
hub, or router
hub, or router
•
power cable to the modem power connector and to facility power
3
Refer to
, to check modem LED status indications.
Ensure that the NIC in the PC and the modem LAN port are both set to either
half- or full-duplex for the transmission direction(s). If you need to change the
modem LAN port setting to match the NIC, follow the procedures in
half- or full-duplex for the transmission direction(s). If you need to change the
modem LAN port setting to match the NIC, follow the procedures in
Wall jack with
DSL service
DSL service
DSL LINE
PO
WER
DSL line
port
Power
connector
connector
MD
I
MD
I-X
10BASE-T
CONSOLE
PC, hub or other
network device
network device
10Base-T
port
M0152-B