Cabletron Systems SEHI100TX- Manuel D’Utilisation

This section contains procedures on how to install the EPIM-100TX or 
the EPIM-100FX to upgrade or change the capabilities of your SEHI. 
After installing a new EPIM, refer to the appropriate EPIM section in 
Appendix A to verify proper operation.

Install an EPIM-100TX or an EPIM-100FX as follows:

1. Remove the coverplate or the existing EPIM (whichever applies).

2. Slide the new EPIM into place, making sure that the connectors on the 

rear of the EPIM align correctly and firmly with the connector inside 
the SEHI. Refer to Figure 4-7.

3. Install the mounting screw.

Observe all static precautions while handling an EPIM.

When removing an EPIM, pull the module straight out to 
prevent damage to the connector.

1511_09

SEHI Book  Page 9  Wednesday, May 15, 1996  10:42 AM