Cabletron Systems SEHI100TX- Manuel D’Utilisation

Chapter 7: Local Management

6. To exit the screen, press the appropriate Function key or use the arrow 

keys to highlight the RETURN command.

7. Press ENTER. The Feature Selection screen appears.

To access the Configuration screen from the Feature Selection screen, use 
the arrow keys to highlight the IP Address Assignment option, then 
press ENTER or F7. The screen shown in Figure 7-5 appears.

Assign the IP Address, Subnet Mask, and Default Gateway through the 
SEHI Configuration screen. Use the Port Enable Override option to 
enable all device ports in the stack. This option overrides the Port Disable 
setting in the Statistics screen.

The following sections explain each field on the Configuration screen and 
instructions on how to change them.

The first time a user attempts to exit the screen without saving 
the changes, a “NOT SAVED?” message is displayed. The 
edits are lost if the user proceeds to exit without saving the 
changes.

Cabletron  SEHI Revision X.XX.XX

CONFIGURATION

SEHI  LOCAL MANAGEMENT

SAVE      COMMUNITY NAMES     TRAP TABLE      SNMP TOOLS        RETURN

  F6                         F7                                  F8                          F9

I/F                IP Address                SubNET Mask                MAC Address

 1                 000.000.000.000     000.000.000.000          00-00-1d-05-dc-36

Default Gateway: 0.0.0.0

Serial Port 1 Application: CONSOLE     Baud Rate: 9600  --ACTIVE-
-

Port Enable Override:  OVERRIDE DISABLED

1490_24

SEHI Book  Page 10  Wednesday, May 15, 1996  10:42 AM