IBM 8271 Manuel D’Utilisation
8271 N
WAYS
M
ATRIX
S
TACKING
S
WITCH
M
ODULE
U
SER
’
S
G
UIDE
Introduction
With the 8271 Nways Matrix Stacking Switch Module
(02L0882) installed into your 8271 Nways Switch, you can
connect up to four Switches over high speed links, in a
single stack. This stack can then be managed as a single
unit with one IP address.
(02L0882) installed into your 8271 Nways Switch, you can
connect up to four Switches over high speed links, in a
single stack. This stack can then be managed as a single
unit with one IP address.
The Matrix Module can be installed into the following
models of 8271 Nways Ethernet LAN Switches:
models of 8271 Nways Ethernet LAN Switches:
■
8271 Nways Ethernet LAN Switch Models E12 and E24
■
8271 Nways Ethernet LAN Switch Models F12 and F24
A stack can consist of any combination of Switch Model
E12/E24 and Switch Model F12/F24 units.
E12/E24 and Switch Model F12/F24 units.
You do not need a Matrix Module if you are connecting two
Switches back-to-back. You can connect two units using
the Matrix port located on the rear of the Switch and a
Switch Matrix Cable.
Switches back-to-back. You can connect two units using
the Matrix port located on the rear of the Switch and a
Switch Matrix Cable.
You can find more information on stacking units in the
user’s guide that accompanies your Switch.
user’s guide that accompanies your Switch.
Before Installation
ATTENTION: Before installing the Matrix Module into a
Switch, you must disconnect the Switch from the mains
power supply.
Switch, you must disconnect the Switch from the mains
power supply.
For full safety instructions, refer to the appropriate Switch
User’s Guide.
User’s Guide.
DANGER:
SD21-0030.
Handling the Matrix Module
The Matrix Module can be easily damaged by electrostatic
discharge. To prevent damage, please observe the follow-
ing:
discharge. To prevent damage, please observe the follow-
ing:
■
Do not remove the Matrix Module from its packaging
until you are ready to install it.
until you are ready to install it.
■
Do not touch any of the connectors or components on
the Matrix Module.
the Matrix Module.
■
Handle the Matrix Module only by its edges and front
panel.
panel.
■
Always wear an anti-static wristband connected to a
suitable earth point.
suitable earth point.
■
Always transport or store the Module in appropriate
anti-static packaging.
anti-static packaging.
Usermatrix.fm Page 1 Thursday, June 25, 1998 1:16 PM