ICP DAS USA SAGP-845EV Manuel D’Utilisation

 
The user can set the password for either supervisor or user,, or for both 
of them.  

supervisor password: for entering and changing the settings of the     

system 

 
user password: for just entering the system but does not have the 

privilege to change any settings of the system 

 
If this function is enabled, the following message will appear to guide the 
user to create a         password. 
 
 
  ENTER PASSWORD: 
 
Type the password, up to eight characters in length, and press <Enter>.  
The password typed now will clear any previously entered password from 
CMOS memory.  The user will be asked to re-type the password, and 
press <Enter>.   
 
Note: The user may press <Esc> to skip the selection and not to enter a   

password. 

 
To disable a password, just press <Enter> when prompted to enter the 
password. Once the password is disabled, the system will boot and the 
user can enter Setup freely. 
   
PASSWORD DISABLED: 
When a password has been set, the user will be prompted to enter it 
every time when entering Setup.  This prevents an unauthorized user 
from changing any part of the system configuration. 
 
Additionally, when a password is set, the user can also require the BIOS 
to request a password every time the system starts.  This would prevent 
any unauthorized use of the computer.   
 
The user determines when the password is required within the BIOS 
Features Setup Menu and its security option (see Section 3).  If the 
security option is set to “password”, then it will be required both at boot