Cabletron Systems 3T02-04 Manuel D’Utilisation

 

Configuring

maintained in non-volatile memory and are saved across power cycles. 
Filtering information is covered in the ATX User Guide.

After the ring speed is set, you may connect the module to a network and 
then complete the software configuration, or you could complete all the 
software configurations and then attach the module to a network. 

Connect the Local Console Manager (LCM) to the ATX. Refer to 
Chapter 2, Installation, of the ATX User Guide for specific instructions. 

Make sure the ATX is powered on and press the <Return> key twice. 
When the ATX> prompt appears LCM is ready to use.

Refer to the ATX User Guide for the generic LCM commands. Familiarize 
yourself with LCM before configuring the module. 

Specific instructions for setting the ring speed, enabling/disabling a port’s 
bridging type, and translations for the Token Ring module follow in this 
chapter. 

If you are enabling IP routing, you need to assign addresses to the ports 
which will be performing routing functions. Refer to the ATX User Guide 
for instructions on assigning an IP address.

Once the Token Ring module is installed in the ATX, the ring 
speed must be configured prior to connecting the module to a 
network. The default ring speed is 4 Mbps; the ring speed only 
needs to be configured if your network is running at 16 Mbps.