Cabletron Systems 3T02-04 Manuel D’Utilisation

Chapter 3: Configuring

ATX> translate 

To display the translations that have been activated for indicated ports, 
enter 

translate

 followed by a Token Ring port range. For example:

ATX> translate 2-4

To display the options that are available for the specified translation type, 
enter:

ATX> translate port range translation type

Token Ring ports may have any combination of the different translation 
types. To enable the translation type in the manner specified by option for 
the indicated ports, enter:

ATX> translate {port range} {translation type} option

To disable all translation types for the indicated ports enter:

ATX> translate {port range} none

The ARP translation options are intended to compensate for any likely 
implementation of IP's ARP on 802.5 Token Rings. The possibilities for 
option are the following:

•

Off – no special ARP translation to be performed

•

Bitswap1 – embedded MAC addresses for ARP packets with hardware 
type 1 (Ethernet) will be bit swapped (this applies to all ARP packets 
received by the port, and to all ARP packets to be transmitted by the 
port).

•

Bitswap6 – embedded MAC addresses for ARP packets with hardware 
type 6 (IEEE 802) will be bit swapped (this applies to all ARP packets 
received by the port, and to all ARP packets to be transmitted by the 
port).

•

Bitswap61 – both type 1 and type 6 ARP packets will be bit swapped.

•

Oneto6 – incoming type 6 ARP packets will be changed to type 1 and 
outgoing type 1 ARP packets will be changed to type 6, both without 
bit swapping.