Cabletron Systems 6A000 Manuel D’Utilisation

SmartCell 6A000 User Guide   Appendix B-7

Agent Support

Managing the SmartCell 6A000  

atmIfAdminAddrTable

atmVclAddrBindTable

atmAddrVclTable

atmVplStatTable

atmVplLogicalPortTable

atmVclGenTable

atmfMyOsiNmNsapAddress

atmfVpcTable

lecRouteDescrTable

leRDArpTable

B.2

MANAGING THE SMARTCELL 6A000

Your SmartCell 6A000 must be IP reachable by the NMS before it can be managed. The default connection between 
the SmartCell 6A000 and the NMS is the SmartCell 6A000 Ethernet interface. Use the 

 command 

to find the IP address of the SmartCell 6A000. An NMS can use this IP address to reach the SmartCell 6A000 through  
Ethernet. An NMS can also manage the SmartCell 6A000 through one of its ATM ports if the SmartCell 6A000 has a 
client connection into a VLAN or emulated LAN.

Note that the SmartCell 6A000 itself, is not reachable through ATM until a client for the switch is created and 
participates as a member of a VLAN or ELAN. Your NMS uses that switch client’s address to access and manage the 
switch. 

To create a client for the switch, use the 

 command for VLANs and 

 for emulated 

LANs. 

Use the 

 command to tell the SmartCell 6A000 which interface to use when communicating with your 

NMS. For detailed information about these commands, see the SmartCell 6A000/ZX-250 Reference Manual.

B.2.1

Console Commands that Affect the Agent

The following is a list of the console commands that affect the operation of the SmartCell 6A000 SNMP agent. For 
detailed descriptions of these commands, see the SmartCell 6A000/ZX-250 Reference Manual.

Community:  Sets the community strings for the SmartCell 6A000 

TrapCommunity:  Specifies the NMS to which traps are sent

MyNMAddr: Specifies the IP address through which the switch is managed

TrustedNMS:Specifies the IP address of the NMS allowed to perform the following commands: