Kingston Technology KNS1600 Manuel D’Utilisation
Front Panel
5
KNS1600/R User’s Guide - Rev. A00
Kingston Technology Company
3.
Make sure the cable is wired properly and connected on both
ends.
ends.
4.
Make sure the correct cable type has been selected.
5.
If steps 1 through 4 are correct, please check the cable, as it
may be defective or wired incorrectly. Replace the cable and
try again. Please refer to Appendix A for Pin Assignments
and Appendix B for Cabling Guidelines.
may be defective or wired incorrectly. Replace the cable and
try again. Please refer to Appendix A for Pin Assignments
and Appendix B for Cabling Guidelines.
Full Duplex and Collision LED
The FDX/COLL LED uses a dual color LED to display two functions. A solid
green light indicates that Full-Duplex operation has been detected. A flashing
amber light indicates that a collision has occurred in half-duplex mode. Full-
Duplex mode is auto-negotiated on all UTP ports.
green light indicates that Full-Duplex operation has been detected. A flashing
amber light indicates that a collision has occurred in half-duplex mode. Full-
Duplex mode is auto-negotiated on all UTP ports.
UTP Ports
The Fast EtheRx Switch has sixteen (16) 10/100Mbps UTP ports that auto-
negotiate 10/100BASE-TX connections and half- or full-duplex mode
operation. The last UTP port has two RJ-45 port connectors for support of
UTP cabling in the crossover or straight-through wiring configuration. Only
one of the two ports may be utilized.
negotiate 10/100BASE-TX connections and half- or full-duplex mode
operation. The last UTP port has two RJ-45 port connectors for support of
UTP cabling in the crossover or straight-through wiring configuration. Only
one of the two ports may be utilized.
The RJ-45 port marked
is internally crossed like all other UTP ports. By
default, all repeater and switched UTP ports are generally configured as
standard MDI-X, or internally crossed ports. With a straight-through cable, this
port can be used for cascading to a standard MDI device, such as a network
adapter or router. With a crossover cable, this port can be used for cascading to
another MDI-X device, such as a hub.
standard MDI-X, or internally crossed ports. With a straight-through cable, this
port can be used for cascading to a standard MDI device, such as a network
adapter or router. With a crossover cable, this port can be used for cascading to
another MDI-X device, such as a hub.
The RJ-45 port marked
is a standard straight-through port. With a
crossover cable, this port can be used for cascading to another MDI device,
such as a network adapter or router. With a straight-through cable, this port can
be used for cascading to an internally crossed MDI-X device, such as a
repeater, or hub.
such as a network adapter or router. With a straight-through cable, this port can
be used for cascading to an internally crossed MDI-X device, such as a
repeater, or hub.