Juniper Networks EX8208 Manuel D’Utilisation
Figure 61: Installing a Line Card with a 4-in. Ejector Lever
9.
Tighten the captive screws on the faceplate of the line card by using the screwdriver.
10.
Verify that the
ON
LED starts blinking in green. When the
ON
LED is lit steadily, the
line card is ready for use. If the
ON
LED does not blink or is not lit steadily, see
CAUTION: After the
ON
LED is lit steadily, wait for at least 30 seconds before installing
another line card or removing a line card.
You can verify that the line card is functioning correctly by issuing the
show chassis fpc
and
show chassis fpc pic-status
commands.
NOTE: If you have a Juniper J-Care service contract, register any addition, change, or
upgrade of hardware components at
upgrade of hardware components at
. Failure to
do so can result in significant delays if you need replacement parts. This note applies
if you change the type of line card. It does not apply if you replace these components
with the same type of component.
if you change the type of line card. It does not apply if you replace these components
with the same type of component.
Related Topics
•
•
•
•
•
Installing a Transceiver in an EX Series Switch
The transceivers for EX Series switches are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the switch or disrupting switch functions.
field-replaceable units (FRUs): You can remove and replace them without powering off
the switch or disrupting switch functions.
Use only optical transceivers and optical connectors purchased from Juniper Networks
for your EX Series switch.
for your EX Series switch.
163
Copyright © 2010, Juniper Networks, Inc.
Chapter 9: Installing Switch Components