DELL S50V Manuel D’Utilisation
758
|
PIM Sparse-Mode
www.dell.com | support.dell.com
Related Configuration Tasks
•
•
•
•
•
•
•
•
•
Enable PIM-SM
You must enable PIM-SM on each participating interface:
Display which interfaces are enabled with PIM-SM using the command
show
[
ip | ipv6
]
pim interface
from
EXEC Privilege mode, as shown in
.
Figure 34-1. Viewing PIM-SM Enabled Interfaces
Display PIM neighbors for each interface using the command
show
[
ip | ipv6
]
pim neighbor
from EXEC
IP Version
Task
Command
Command Mode
IPv4
Enable PIM-Sparse Mode on an interface.
ip pim sparse-mode
INTERFACE
IPv6
Enable PIM-Sparse Mode on an interface.
ipv6 pim sparse-mode
INTERFACE
Note: You can influence the selection of the Rendezvous Point by enabling PIM-Sparse Mode on a
loopback interface and assigning a low IP address.
loopback interface and assigning a low IP address.
FTOS#show ip pim interface
Address Interface VIFindex Ver/ Nbr Query DR DR
Mode Count Intvl Prio
189.87.5.6 Gi 4/11 0x2 v2/S 1 30 1 127.87.5.6
189.87.3.2 Gi 4/12 0x3 v2/S 1 30 1 127.87.3.5
189.87.31.6 Gi 7/11 0x0 v2/S 0 30 1 127.87.31.6
189.87.50.6 Gi 7/13 0x4 v2/S 1 30 1 127.87.50.6
FTOS#