Q-Logic 64 Manuel D’Utilisation

B – Command Line Interface

Reset Command

59043-03 A

B-29

D

Resets the switch configuration parameters. If you omit the keyword, the default is 
Reset Switch.

Admin session

blade [slot_number]
config [config_name]
factory
port [port_number]
security
snmp
switch (default)
system
zoning

blade [slot_number]
Resets the I/O or cross-connect blade that occupies the slot given by 
[slot_number]. I/O blade slot numbers are 1–4 and 6–9; cross-connect slot 
numbers are 11–12.
config [config_name]
Resets the configuration given by [config_name] to the factory default values for 
switch, port, alarm threshold, and zoning configuration. If [config_name] does not 
exist on the switch, a configuration with that name will be created. If you omit 
[config_name], the active configuration is reset. You must activate the 
configuration for the changes to take effect. Refer to 

 through 

for switch, port, and alarm threshold configuration default values.
factory
Resets switch configuration, port configuration, alarm threshold configuration, 
zoning configuration, SNMP configuration, system configuration, security 
configuration, and zoning to the factory default values. The switch configuration is 
activated automatically. Refer to 

 through 

port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning 
with 0.
security
Clears the security database and deactivates the active security set. The security 
configuration value, autosave, and fabric binding remain unchanged. Refer to 

 for security configuration default values.

snmp
Resets the SNMP configuration settings to the factory default values. Refer to 

 for SNMP configuration default values.