Q-Logic 64 Manuel D’Utilisation

B – Command Line Interface
Set Config Command

B-42

59043-03 A

D

Sets switch, blade, port, alarm threshold, security, and zoning configuration 
parameters.

Admin session and a Config Edit session

blade [slot_number]
port [port_number]
ports [port_number]
security
switch
threshold
zoning

blade [slot_number]
Initiates an edit session in which to change configured administrative state for an 
I/O or cross-connect blade occupying the slot given by [slot_number]. If you omit 
[slot_number], the system begins with slot 1 and proceeds in order through slot 
12. Slots 1–4 and 6–9 are I/O blades; slots 11–12 are cross-connect blades. Enter 
a new value or press the Enter key to accept the current value shown in brackets. 
Enter “q” to end the configuration for one blade, or “qq” to end the configuration for 
all blades.
port [port_number]
Initiates an edit session in which to change configuration parameters for the port 
number given by [port_number]. If you omit [port_number], the system begins with 
port 0 and proceeds in order through the last port. For each parameter, enter a 
new value or press the Enter key to accept the current value shown in brackets. 
Enter “q” to end the configuration for one port, or “qq” to end the configuration for 
all ports. 

 describes the port parameters.

ports [port_number]
Initiates an editing session in which to change configuration parameters for all 
ports based on the configuration for the port given by [port_number]. If you omit 
[port_number], port 0 is used. For each parameter, enter a new value or press the 
Enter key to accept the current value shown in brackets. Enter “q” to end the 
configuration. 

 describes the port parameters.

AdminState

Port administrative state: online, offline, 
diagnostics, or down. The default is 
online.

LinkSpeed

Transmission speed: 1Gb/sec, 2 
Gb/sec, or Auto. The default is Auto.