Q-Logic 64 Manuel D’Utilisation
59043-03 A
4-1
Section 4
Installation
This section describes how to install and configure the SANbox2-64 switch. It also
describes how to load new firmware and how to recover a disabled switch.
describes how to load new firmware and how to recover a disabled switch.
4.1
Site Requirements
Consider the following items when installing a SANbox2-64 switch:
Fabric management workstation
Power requirements
Environmental conditions
4.1.1
Fabric Management Workstation
The requirements for fabric management workstations running SANbox Manager
are described in
are described in
:
Telnet workstations require an RJ-45 Ethernet port or an RS-232 serial port and
an operating system with a Telnet client.
an operating system with a Telnet client.
4.1.2
Switch Power Requirements
Operating voltage requirements are as follows:
90 to 264 VAC; 47 to 63 Hz
Table 4-1. Management Workstation Requirements
Operating System
Windows® NT, 2000, 95/98
Linux® 7.2 Red Hat®
Solaris™
Memory
128 MB or more
Disk Space
150 MB per installation
Processor
300 MHz or faster
Hardware
CD-ROM drive, RS-232 serial port,
RJ-45
Ethernet port
Internet Browser
Microsoft® Internet Explorer® or Netscape Navigator®