Nortel Networks CVX 600 Manuel D’Utilisation
Replacing Modules and Filler Panels
3-4
296-1011-202 Rel. 5.0, Doc. Rev. 02.01
CVX 600 Hardware Installation Guide
Replacing Modules and Filler Panels
Introduction
This section provides instructions for replacing chassis components and hardware
modules. It describes how to:
modules. It describes how to:
•
Remove and install filler panels
•
Replace the SCC-SM
•
Replace the SCC-LTM or SCC-RLTM
•
Replace other service modules (SMs)
•
Replace DAC-LTMs and DAC-RLTMs
Removing and Installing Filler Panels
You must install filler panels in any empty slots at the front or rear of the
CVX 600 chassis. Filler panels ensure proper air circulation in the chassis, as well
as assist in emissions compliance. If you need to install a card in an empty slot,
you must first remove the filler panel.
CVX 600 chassis. Filler panels ensure proper air circulation in the chassis, as well
as assist in emissions compliance. If you need to install a card in an empty slot,
you must first remove the filler panel.
Note:
You must wear an antistatic wrist strap when you remove or install
these components and modules.