Nortel Networks CVX 600 Manuel D’Utilisation

1-16

296-1011-202 Rel. 5.0, Doc. Rev. 02.01 

CVX 600 Hardware Installation Guide

Before you install the CVX 600 chassis, ensure that you have all of the necessary 
tools, cables, console equipment, and mounting hardware.

You must have the following tools:

•

Screwdrivers:

— Phillips #2 screwdriver

— 1/16-inch and 1/4-inch flat-tip screwdrivers

•

Nut drivers (nonmetric sizes) for securing power and ground cabling

•

Volt/ohm meter for power connections

The shipment does not include the cables required for the telephone side of your 
network. Ensure that the installation site has the proper network cabling.

Cable ties are needed to bundle network and power cables, to provide access to 
LTM and RLTM modules.

You can connect a local terminal or a PC to the CVX 600 to monitor startup 
diagnostics and to perform manual startup and configuration. See 

 for information on installing a service console. See the 

following software manuals for information on configuring the CVX 600 access 
switch: