Q-Logic SN0135524-00 Manuel D’Utilisation
IBM eServer BladeCenter Fibre Channel Switch Module
Principal Switch Configuration
Principal Switch Configuration
P
AGE
136
QL
OGIC
S
WITCH
I
NTEROPERABILITY
G
UIDE
V
ERSION
1.0, M
ARCH
2003
QLogic CLI
NOTE:
Use the CLI commands when the QLogic SANbox Manager GUI is not available. The
procedures are the same for the QLogic SANbox2-8, SANbox2-16, and SANbox2-64.
procedures are the same for the QLogic SANbox2-8, SANbox2-16, and SANbox2-64.
Login: admin
Password: xxxxxxxx
SANbox2 #> show config switch
Use the above command to verify that R_A_TOV is set to 10000 and E_D_TOV is set to 2000. If
these timeout values are not correct, continue with this section. If the settings are correct, no
changes need to be made; proceed with the next appropriate section.
these timeout values are not correct, continue with this section. If the settings are correct, no
changes need to be made; proceed with the next appropriate section.
SANbox2 #> admin start
SANbox2 (admin) #> config edit
SANbox2 (admin-config) #> set config switch
The following options display:
AdminState (1=Online, 2=Offline, 3=Diagnostics) [Online]
BroadcastEnabled (True / False) [True]
InbandEnabled (True / False) [True]
DefaultDomainID (decimal value, 1-239) [1]
DomainIDLock (True / False) [True]
SymbolicName (string, max=32 chars) [QLogic SANbox2-64]
R_T_TOV (decimal value, 1-1000 msec) [100]
R_A_TOV (decimal value, 100-100000 msec) [9000]
10000
E_D_TOV (decimal value, 10-20000 msec) [1000]
2000
FS_TOV (decimal value, 100-100000 msec) [5000]
DS_TOV (decimal value, 100-100000 msec) [5000]
PrincipalPriority (decimal value, 1-255) [254]
ConfigDescription (string, max=64 chars) [Default Config]
SANbox2 (admin-config) #> config save
SANbox2 (admin) #> config activate
The configuration will be activated.
Please confirm (y/n): [n] y
Principal Switch Configuration
IBM eServer BladeCenter Fibre Channel Switch Modules and QLogic SANblade switches negotiate
for principal switch automatically. Therefore, there are no steps to take.
for principal switch automatically. Therefore, there are no steps to take.