Q-Logic SANBOX2-8C Manuel D’Utilisation
5 – Diagnostics/Troubleshooting
POST Diagnostics
5-2
59042-00 A
5.1.1.2
Force PROM Mode Pattern
Steady illumination indicates that the switch is in force PROM mode, which returns
the switch IP address to 10.0.0.1. From force PROM mode, you may reload
firmware, reset the password to the factory default, and remove a corrupt
configuration.
the switch IP address to 10.0.0.1. From force PROM mode, you may reload
firmware, reset the password to the factory default, and remove a corrupt
configuration.
5.1.1.3
Internal Firmware Failure Blink Pattern
An internal firmware failure blink pattern is 2 blinks per second followed by a two
second pause. The 2-blink error pattern indicates that the firmware has failed, and
that the switch must be reset.
second pause. The 2-blink error pattern indicates that the firmware has failed, and
that the switch must be reset.
5.1.1.4
Fatal Error Blink Pattern
A fatal error blink pattern is 3 blinks per second followed by a two second pause.
The 3-blink error pattern indicates that a fatal error has left the switch inoperable.
If a fatal error occurs, contact your authorized maintenance provider.
The 3-blink error pattern indicates that a fatal error has left the switch inoperable.
If a fatal error occurs, contact your authorized maintenance provider.
5.1.1.5
Configuration File System Error Blink Pattern
A configuration file system error blink pattern is 4 blinks per second followed by a
two second pause. The 4-blink error pattern indicates that a configuration file
system error has occurred, and that a Remake File System procedure is
necessary to return the switch to a normal state. Refer to
two second pause. The 4-blink error pattern indicates that a configuration file
system error has occurred, and that a Remake File System procedure is
necessary to return the switch to a normal state. Refer to
for more information.
2 seconds
1 second
2 seconds
1 second
2 seconds
1 second