Q-Logic SANBOX Manuel D’Utilisation
4 – MIB-II Objects
59047-03 B
4-55
A
egpNeighMode (1.3.6.1.2.1.8.5.1.14)
The polling mode of this EGP entity, either passive or active.
Syntax
INTEGER { active(1), passive(2) }
Access
read-only
Status
mandatory
egpNeighEventTrigger (1.3.6.1.2.1.8.5.1.15)
A control variable used to trigger operator-initiated Start and Stop events. When
read, this variable always returns the most recent value that egpNeighEvent-
Trigger was set to. If it has not been set since the last initialization of the network
management subsystem on the Node, it returns a value of “stop”.
read, this variable always returns the most recent value that egpNeighEvent-
Trigger was set to. If it has not been set since the last initialization of the network
management subsystem on the Node, it returns a value of “stop”.
When set, this variable causes a Start or Stop event on the specified neighbor, as
specified on pages 8-10 of RFC 904. Briefly, a Start event causes an Idle peer to
begin neighbor acquisition and a non-Idle peer to re-initiate neighbor acquisition.
A stop event causes a non-Idle peer to return to the Idle state until a Start event
occurs, either by egpNeighEventTrigger or otherwise.
specified on pages 8-10 of RFC 904. Briefly, a Start event causes an Idle peer to
begin neighbor acquisition and a non-Idle peer to re-initiate neighbor acquisition.
A stop event causes a non-Idle peer to return to the Idle state until a Start event
occurs, either by egpNeighEventTrigger or otherwise.
Syntax
INTEGER { start(1), stop(2) }
Access
read-write
Status
mandatory
egpAs (1.3.6.1.2.1.8.6)
The autonomous system number of this EGP entity.
Syntax
INTEGER
Access
read-only
Status
mandatory