Q-Logic 59047-09 C Manuel D’Utilisation

4 – MIB-II Objects

The EGP Neighbor Table

59047-09  C

4-51

A

INTEGER

read-only

mandatory

The polling mode of this EGP entity, either passive or active.

INTEGER { active(1), passive(2) }

read-only

mandatory

A control variable used to trigger operator-initiated Start and Stop events. When 
read, this variable always returns the most recent value that 
egpNeighEventTrigger was set to. If it has not been set since the last initialization 
of the network management subsystem on the Node, it returns a value of “stop”.

When set, this variable causes a Start or Stop event on the specified neighbor, as 
specified on pages 8-10 of RFC 904. Briefly, a Start event causes an Idle peer to 
begin neighbor acquisition and a non-Idle peer to re-initiate neighbor acquisition. 
A stop event causes a non-Idle peer to return to the Idle state until a Start event 
occurs, either by egpNeighEventTrigger or otherwise.

INTEGER { start(1), stop(2) }

read-write

mandatory