Q-Logic 59022-11 A 4-13 Manuel D’Utilisation
A – Command Line Interface
Reset Command
59022-11 A
A-45
0
services
Resets the switch services configuration to the default values as described in
Resets the switch services configuration to the default values as described in
.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
Resets the SNMP configuration settings to the factory default values. Refer to
for SNMP configuration default values.
switch
Resets the switch without a power-on self test. This is the default. This reset
disrupts traffic and does the following:
Resets the switch without a power-on self test. This is the default. This reset
disrupts traffic and does the following:
Activates the pending firmware.
Closes all management sessions.
Clears the event log. To save the event log before resetting, refer to the
To reset the switch with a power-on self test, refer to the
.
system
Resets the system configuration settings to the factory default values. as
described in
Resets the system configuration settings to the factory default values. as
described in
zoning
Clears the zoning database and deactivates the active zone set. The zoning
configuration values (autosave, default visibility) remain unchanged.
Clears the zoning database and deactivates the active zone set. The zoning
configuration values (autosave, default visibility) remain unchanged.
Note:
Because this keyword changes network parameters, the
workstation could lose communication with the switch.
workstation could lose communication with the switch.