Q-Logic 59042-07 A Manuel D’Utilisation

B – Command Line Interface
Reset Command

B-30

59042-07 A

0

Resets the switch configuration parameters. If you omit the keyword, the default is 
Reset Switch.

Admin session

config [config_name]
factory
port [port_number]
snmp
switch (default)
system
zoning

config [config_name]
Resets the configuration given by [config_name] to the factory default values for 
switch, port, port threshold alarm, and zoning configuration. If [config_name] does 
not exist on the switch, a configuration with that name will be created. If you omit 
[config_name], the active configuration is reset. You must activate the 
configuration for the changes to take effect. Refer to 

 through 

for switch, port, and port threshold alarm configuration default values.
factory
Resets switch configuration, port configuration, port threshold alarm configuration, 
zoning configuration, SNMP configuration, system configuration, and zoning to 
the factory default values. The switch configuration is activated automatically. 
Refer to 

 through 

.

port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning 
with 0.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to 

 for SNMP configuration default values.

switch
Resets the switch without a power-on self test. This is the default. This reset 
disrupts traffic and does the following:
„

Activates the pending firmware.

„

Closes all management sessions.

Because this keyword changes network parameters, the 
workstation could lose communication with the switch and 
release the Admin session.