Q-Logic 5200 Manuel D’Utilisation

3 – Managing Fabrics

Zoning a Fabric

59056-02 A

3-25

0

To edit the zoning database for a particular switch, open the Zoning menu from 
the faceplate display and select Edit Zoning to open the Edit Zoning dialog 
shown in 

. Changes can only be made to inactive zone sets, which are 

stored in flash (non-volatile) memory and retained after resetting a switch.

To apply zoning to a fabric, choose a zone set and activate it. When you activate a 
zone set, the switch distributes that zone set and its zones, excluding aliases, to 
every switch in the fabric. This zone set is known as the active zone set.

You can not edit an active zone set on a switch. You must configure an inactive 
zone set to your needs and then activate that updated zone set to apply the 
changes to the fabric. When you activate a zone set, the switch distributes that 
zone set to the temporary zoning database on every switch in the fabric. However, 
in addition to the merged active zone set, each switch maintains its own original 
zone set in its zoning database. Only one zone set can be active at one time.

Port/Device 

Tree

Zone Sets 

Tree