Nortel Networks 1000ASE-XD Manuel D’Utilisation

Chapter 3 Using the console interface

209418-A

The Renumber Stack Units screen (

) allows you to renumber the units 

configured in the stack. When selected, this option identifies the unit number of 
each unit in the stack configuration by lighting the corresponding number of (100 
Mb/s port) LEDs on each unit for approximately 10 seconds. For example, unit 3 
will display three LEDs.

To open the Renumber Stack Units screen:

Renumber Stack Units screen

Note: This menu option and screen appears only when the switch is 
participating in a stack configuration.

Choose Renumber Stack Units (or press n) from the main menu.

                             Renumber Stack Units 
 
 
  Current Unit Number              MAC Address           New Unit Number 
  -------------------    ----------------------------    --------------- 
        [  1  ]                00-60-fd-77-a6-0c              [  1  ] 
        [  2  ]                00-60-fd-77-a5-f0              [  2  ] 
        [  3  ]                00-60-fd-77-a4-4c              [  3  ] 
        [  4  ]                00-60-fd-77-ab-84              [  4  ] 
 
 
 
Renumbering stack units will cause an automatic Reset to Current Settings to 
occur across the entire stack.  The current configuration will be adapted to 
the new numbering scheme. Check the stack configuration after the reset to 
confirm the desired configuration is set. 
 
Are you sure you want to renumber switches with the new settings?   [ No  ] 
 
 
 
Use space bar to display choices, press <Return> or <Enter> to select choice. 
Press Ctrl-R to return to previous menu.  Press Ctrl-C to return to Main Menu.