Raritan Engineering KX2-864 Manuel D’Utilisation
Chapter 12: Command Line Interface (CLI)
219
Interface Command
The Interface command is used to configure the Dominion KX II network
interface. The syntax of the interface command is:
interface. The syntax of the interface command is:
interface [ipauto <none|dhcp>] [ip <ipaddress>] [mask
<subnetmask>] [gw <ipaddress>] [mode <mode>]
<subnetmask>] [gw <ipaddress>] [mode <mode>]
Set/Get ethernet parameters
ipauto <none|dhcp> IP auto configuration (none/dhcp)
ip <ipaddress> IP Address
mask <subnetmask> Subnet Mask
gw <ipaddress> Gateway IP Address
mode <mode> Set Ehternet Mode
(auto/10hdx/10fdx/100hdx/100fdx/1000fdx)
(auto/10hdx/10fdx/100hdx/100fdx/1000fdx)
Interface Command Example
The following command enables the interface number 1, sets the IP
address, mask, and gateway addresses, and sets the mode to auto
detect.
address, mask, and gateway addresses, and sets the mode to auto
detect.
Admin > Config > Network > interface ipauto none ip
192.16.151.12 mask 255.255.255.0 gw 192.168.51.12 mode
auto
192.16.151.12 mask 255.255.255.0 gw 192.168.51.12 mode
auto
Note: Both IPv4 and IPv6 addresses are supported.
Name Command
The name command is used to configure the network name. The syntax
of the name is:
of the name is:
name [devicename <devicename>] [hostname <hostname>]
Device name configuration
devicename <devicename> Device Name
hostname <hostname> Preferred host name (DHCP
only)
only)
Name Command Example
The following command sets the network name:
Admin > Config > Network > name devicename My-KSX2