Netgear M4100-50G Manuel D’Utilisation

Static MAC Filtering

The commands in this section describe how to configure static MAC filtering. Static MAC 
filtering allows you to configure destination ports for a static multicast MAC filter irrespective 
of the platform. 

This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN 
<vlanid>

. The value of the <macaddr> parameter is a 6-byte hexadecimal number in the 

format of b1:b2:b3:b4:b5:b6. The following MAC addresses are restricted: 00:00:00:00:00:00, 
01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and 
FF:FF:FF:FF:FF:FF. The <vlanid> parameter must identify a valid VLAN. 

The number of static mac filters supported on the system is different for MAC filters where 
source ports are configured and MAC filters where destination ports are configured. 

For unicast MAC address filters and multicast MAC address filters with source port lists, 

the maximum number of static MAC filters supported is 20.

For multicast MAC address filters with destination ports configured, the maximum number 

of static filters supported is 256.

For example, for current platforms you can configure the following combinations:

Unicast MAC and source port (max = 20)

Multicast MAC and source port (max=20)

Multicast MAC and destination port (only) (max=256)

Multicast MAC and source ports and destination ports (max=20)

show monitor session

 

Privileged EXEC

An integer value used to identify the session. Its value can be anything between 1 and 

the maximum number of mirroring sessions allowed on the platform.

Indicates whether the Port Mirroring feature is enabled or disabled for the session 
identified with <session-id>. The possible values are Enabled and Disabled.

Probe port (destination port) for the session identified with

 

. If probe port 

is not set, then this field is blank.

The port, which is configured as mirrored port (source port) for the session identified with

 

. 

If no source port is configured for the session, then this field is blank.

Direction in which source port configured for port mirroring. Types are tx for transmitted 
packets and rx for receiving packets.