Netgear M4100-50G Manuel D’Utilisation

set mld querier election participate

Use this command to enable the Snooping Querier to participate in the Querier Election 
process when it discovers the presence of another Querier in the VLAN. When this mode is 
enabled, if the Snooping Querier finds that the other Querier’s source address is better (less) 
than the Snooping Querier’s address, it stops sending periodic queries. If the Snooping 
Querier wins the election, then it will continue sending periodic queries.

Use this command to set the snooping querier not to participate in querier election, but go 
into a non-querier mode as soon as it discovers the presence of another querier in the same 
VLAN.

show mldsnooping querier 

Use this command to display MLD Snooping Querier information. Configured information is 
displayed whether or not MLD Snooping Querier is enabled.

When the optional arguments vlandid are not used, the command displays the following 
information.

disabled 

set mld querier election participate 

VLAN Config

no set mld querier election participate 

VLAN Config

show mldsnooping querier [{detail | vlan <vlanid>}] 

Privileged EXEC

Indicates whether or not MLD Snooping Querier is active on the switch.

Indicates the version of MLD that will be used while sending out the queries. This is 
defaulted to MLD v1 and it cannot be changed.

Shows the IP address which will be used in the IPv6 header while sending out MLD 
queries. It can be configured using the appropriate command.

Shows the amount of time in seconds that a Snooping Querier waits before sending 
out the periodic general query.

Displays the amount of time to wait in the Non-Querier operational state before moving 
to a Querier state.