Netgear M4100-50G Manuel D’Utilisation

Open Shortest Path First (OSPF) Commands

This section describes the commands you use to view and configure OSPF, which is a 
link-state routing protocol that you use to route traffic within a network. 

Use this command to enter Router OSPF mode. 

router ospf

This command resets the default administrative mode of OSPF in the router (active). 

enable

This command sets the administrative mode of OSPF in the router to inactive. 

no enable

Use this command to enable OSPFv2 on an interface and set its area ID if the IP address of 
an interface is covered by this network command.

network <ip-address> <wildcard-mask> area <area-id>

The number of packets received with TTL of 0 or 1 that might otherwise have been 
relayed.

The number of packets ignored by the relay agent because they match a discard 
relay entry.

Global Config

enabled

Router OSPF Config

Router OSPF Config

disabled

Router OSPF Config