Netgear M4100-50G Manuel D’Utilisation

 

Any change in the dampening configuration resets the current 

penalty, reuse time, and suppressed state to their default values, 
meaning 0, 0, and FALSE respectively.

The following shows example CLI display output for the command. 

(netgear switch)# show interface dampening 

Interface 0/2 

Flaps   Penalty   Supp   ReuseTm   HalfL   ReuseV   SuppV   MaxSTm   MaxP   Restart 

0          0      FALSE    0          5     1000     2000     20     16000     0 

Interface 0/3 

Flaps   Penalty   Supp   ReuseTm   HalfL   ReuseV   SuppV   MaxSTm   MaxP   Restart 

6        1865     TRUE     18        20     1000     2001     30     2828    1500

Routing Information Protocol (RIP) Commands

This section describes the commands you use to view and configure RIP, which is a 
distance-vector routing protocol that you use to route traffic within a small network. 

Use this command to enter Router RIP mode. 

router rip

This command resets the default administrative mode of RIP in the router (active). 

enable

This command sets the administrative mode of RIP in the router to inactive.

no enable

Global Config

enabled

Router RIP Config

Router RIP Config