Netgear M4100-50G Manuel D’Utilisation

Configuring the Switch Management CPU

To manage the switch via the web GUI or telnet, an IP address needs to be assigned to the 
switch management CPU. Whereas there are CLI commands that can be used to do this, 
ezconfig simplifies the task. The tool is applicable to all NETGEAR 7000-series managed 
switches, and allows you to configure the following parameters:

The administrator’s user password and administrator-enable password

Management CPU IP address and network mask

System name and location information

The tool is interactive and uses questions to guide you through the steps required to perform 
its task. At the end of the session, it will ask you if you want to save the changed information. 
To see exactly what has been changed by ezconfig at the end of the session, use the show 
running-config command.

To perform any switch configuration other than the items listed above, use other CLI 
commands or the web GUI.

This command sets the IP address, subnet mask, and gateway of the device. The IP address 
and the gateway must be on the same subnet.

ezconfig

Privileged EXEC