Netgear M4100-50G Manuel D’Utilisation

This command displays the private-VLAN mapping information for the switch interfaces.

show interface ethernet <slot/port> switchport

• Privileged EXEC

• User EXEC

GARP Commands

This section describes the commands you use to configure Generic Attribute Registration 
Protocol (GARP) and view GARP status. The commands in this section affect both GARP 
VLAN Registration Protocol (GVRP) and Garp Multicast Registration Protocol (GMRP). 
GARP is a protocol that allows client stations to register with the switch for membership in 
VLANS (by using GVMP) or multicast groups (by using GVMP).

This command sets the GVRP join time for one port (Interface Config mode) or all (Global 
Config mode) and per GARP. Join time is the interval between the transmission of GARP 
Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or 
multicast group. This command has an effect only when GVRP is enabled. The time is from 
10 to 100 (centiseconds). The value 20 centiseconds is 0.2 seconds.

set garp timer join <10-100>

• Interface Config

• Global Config

Displays information about the configured private VLANs

Displays only private VLAN ID and its type.

Displays primary VLAN ID

Displays secondary VLAN ID

Displays secondary VLAN type

Displays ports which are associated with a private VLAN

Displays VLAN association for the private-VLAN host ports.

Displays VLAN mapping for the private-VLAN promiscuous ports

20